Mar 11, 2024 Leave a message

How to choose a combiner box

Combiner box is an important electrical component in the power distribution system, and its performance directly affects the stability of the whole system. So, how to choose the right combiner box? This article will introduce you to some experience.

1. Choose according to the use occasion:

1. In the substation, the single-phase AC metal-enclosed switchgear (hereinafter referred to as the circuit breaker) with a rated current greater than or equal to 10A should be selected.

2. In the power plant, the air circuit breaker and leakage protection circuit breaker of the corresponding capacity should be selected according to the different capacity and operating conditions of the generator.

3. When selecting a high-voltage fuse, it should be noted that its breaking capacity is related to the short-circuit current. Generally speaking, the breaking capacity of low-voltage fuses is 15 kA, while those of high voltage fuses can reach more than 40 KA.

4. For high-voltage electrical equipment and lines of 35kV and above, when the insulation coordination and creepage distance requirements are high, zinc oxide arresters can be selected as the terminal protection devices.

2. Choose according to the environment of the place of use:

1. When the ambient temperature exceeds 40 °C, we should consider using radiator type or oil-immersed self-cooling type and other products with simple structure, if the ambient temperature is lower than 0 °C, dry structure products can be selected, and if there are high requirements for humidity, we can choose sealed products, etc. (Note: Due to the low price of heat sink products on the market and easy installation and debugging, they are widely used.) ).

2. When the altitude of the protected equipment and system does not exceed 2000m, the ordinary type can be used, the reinforced type can be selected for 35kv and above, and the high prototype can be used for 40.5kv and above. (Note: The level of protection used varies depending on the altitude).

3. Choose according to the frequency of use:

1. Under normal circumstances, 10~20 times is a cycle to consider what type of switch cabinet is more appropriate. (Note: The cycle here refers to a complete operation process, that is, the time between one closing and the next tripping) such as frequent operation and short working system, which can use fast mechanism products.

2. If the load operation is often carried out (such as motor starting), and the working system is long, the switch cabinet with thermomagnetic mechanism is selected. (Note: "Under load" here refers to continuous operation over a short period of time, not to a long-term operating state.) ).

4. Other precautions:

1. Check whether the parts are intact.

2. Check whether the nameplate parameters meet the design regulations.

3. Check whether the terminal is loose and tighten the screw cap in time.

4. Check whether the control loop is normal and free of phase loss.

5. Check if the grounding is good.

6. Energize the test to see if there is any phenomenon such as ignition and smoke.

 

Send Inquiry

Home

Phone

E-mail

Inquiry